Philips ReCare 7.0 R User Manual page 50

Assembly
Read each step's instructions and study the drawing carefully to become
familiar with all the parts and procedures before beginning each step.
Step 1. Rear stabilizer and handle bar assembly
• Install the Rear Stabilizer (7) onto the Main Frame (1) with the four 3/8" x
2-1/4" Hex Head Bolts (65) and four 3/8" Flat Washers (84).
• This section is easier if you slide the seat carriage (38) all the way back
before starting. Slide the handle bar assembly (6) onto the receiving
tubes of the seat frame (38). Secure the handle bar assembly starting
with the two 3/8" x 2-3/4" bolts (175) (install from the inside hole of the
receiving tube), four at washers (77) and two nuts (89). *Do not tighten
the hardware for this section until the very end, after the safety cover
(242) is attached. Install the four 3/8" x 2" bolts (71) from the top side of
the tubes and assemble the four 3/8" at washers (77) and 3/8" nuts
(89).
• Attach the end of the gas shock (244) to the seat back angle adjustment
bracket and secure with the 5/16" x 1-1/4" bolt (208), two 5/16" at
washers (205) and 5/16" nut (213).
• Connect the left (L) and right (R) hand pulse wires together. Slide the
safety cover (242) onto the handle bar bolts (175), between the frame
and washer & nuts. Tighten all hardware securely.
#283- 8m/m L Allen Wrench (1PC)
#201- Short Phillips Head Screw Driver (1PC)
50