Philips ReCare 7.0 R User Manual page 56

Step 5. Console, seat, pedals and covers assembly
• Install the front and rear stabilizer covers (32 & 37) with the four 5mm
screws (99).
• Install the seat cushion (61) with the four M6 x 25mm bolts (222).
• Plug in all the connectors in their mating sockets in the back of the
console. Install the console onto the mounting plate and secure with
the four 5mm screws (99). Make sure to store the excess wire into the
console mast and check that no wire is caught between the back of
the console and the mounting plate before installing and tightening
the screws. If the wires get pinched between the console and plate,
damage could occur to the electronics.
• Install the left (116) and right (117) pedals onto the crank arms. Remem-
ber that the left pedal has a reverse thread and will be screwed into
the crank in the opposite rotation from normal threads. There is an "L"
stamped into the end of the threaded post of the left pedal and an "R"
in the right. Make sure to tighten the pedals as much as you possibly
can. It may be necessary to re-tighten the pedals if you feel a thump-
ing during pedaling the bike. A noise or feeling such as a thumping or
clicking is usually caused by the pedals not being tight enough.
• Remove the Allen screws from the lever clamps (249), t them onto the
Handle Bar (6) and secure with the Allen screws. Make sure the levers
are positioned under the hand position and they are adjusted so the
patient can comfortably reach them during use. The release levers are
labeled Left and Right; the left lever with gray cable is for the fore/aft
seat adjustment and the right lever with black cable is for the seat
back angle.
#284- 13.14m/m Open wrench (1PC)
#280- 10m/m Wrench_single (1PC)
56