Toshiba TOSVERT VF-S15 Instruction Manual page 8

 Output terminals
Output signal terminals used with the My function-S are following.
● Output terminals (3 terminals: RY, OUT, FL)
VF-S15 has 3 output terminals.
You can assign the multiple functions to the output terminals.
A table of output terminal functions is shown in Appendix 4. Only the positive logic settings
are used for My function-S.
Note) Negative logic settings of output terminal functions cannot be used for the My
Computation results can be output by assigning the My function-S output 1 to 16 to the
output terminals .
 Setting parameters
The My function-S consists of 7 units of the same composition. Each unit consists of 4 steps,
and therefore there are 28 steps in total. See Fig.4-1 for the composition of each unit.
Each step consists of one command.
Each unit begins with a data read (LD) command as step 1 and ends with a data transfer (ST)
command as step 4. You set the commands and objects to step 2 and 3 in accordance with the
requested functions.
Unit 1
Step 1 LD a900
Step 2 a902 →
a901
Step 3 a903 a904
Step 4 ST
a905
function-S.
Step 1 LD
Step 2
a907
Step 3 a909
Step 4 ST
Fig. 4-1 My function-S block diagram
Unit 2
a906
→→
a908
a910
a911
- 7 -
E6581865
Unit 7
Step 1 LD a953
Step 2
a954 a955
Step 3 a956 a957
Step 4 ST
a958