Table 205 Eth-Cfm Support Matrix; Table 205 - Nokia 7302 Basics, Management And Oam Manual

"FD 100/320Gbps NT and FX NT IHub System
Basics, Management and OAM Guide"
There are two locations in the configuration where ETH-CFM is defined. The
domains, associations (including linkage to the service id), MIP creation method,
common ETH-CFM functions and remote MEPs are defined under the top level
eth-cfm command. It is important to note, when Y.1731 functions are required the
context under which the MEPs are configured must follow the Y.1731 specific
formats (domain format of none, MA format icc-format). Once these parameters have
been entered, the MEP and possibly the MIP can be defined within the service under
the SAP or SDP.
This is a general table that indicates the ETH-CFM support for the different services
and endpoints. It is not meant to indicate the services that are supported or the
requirements for those services on the individual platforms.

Table 205

Figure 3
Figure
associations, using the standards defined icons.
Issue: 10
ETH-CFM Support Matrix
Service Ethernet Connection
VPLS SAP
Spoke-SDP
Mesh-SDP
v-VPLS SAP
EPIPE SAP
Spoke-SDP
MEP and MIP
4 shows the detailed IEEE representation of MEPs, MIPs, levels and
3HH-11982-AAAA-TQZZA
Ethernet Connection Fault Management
Down MEP Up MEP
Y Y
Y Y
Y Y
Y Y
N N
Y N
MIP
Y
Y
N
Y
N
Y
171