Philips ReCare 7.0 S User Manual page 47

Step 4. Console and arm assembly
• Connect the computer cable into the back of the console and install
the console (29) onto the console mast and secure with the four 5mm
x 12mm screws (143).
• Install the left and right arms (3&4) and secure with the 3/8" x 5/8"
bolts (216) and use the 3/8" at washers (217) and 3/8" split washers
(243) on the sides of the arms and the 3/8" curved washers (218) on
the front and rear of the arms. Tighten the bolts very securely so the
arms do not loosen up during use.
• Remove the allen screws from the lever clamps (111), t them onto the
handle bar (17) and secure with the allen screws. Make sure the levers
are positioned under the hand position and they are adjusted so the
patient can comfortably reach them during use. The release levers are
labeled left and right; the left lever with gray cable is for the fore/aft
seat adjustment and the right lever with black cable is for the seat
back angle.
21 7
243 21 8
21 6
243
21 6
243 21 6
1 1 1
208 21 4
29
computer cable
1 1 1
47
1 43
21 8
243
243
21 6
21 6
21 8
243
21 7
21 6
243