Internet Enhanced Service
6.10.7.9
Table 360
6.10.7.10
Table 361
6.10.7.11
Table 362
390
server
server command
Item
Description
Syntax
server ipv6-address [ipv6-address...(up to 8 maximum)]
Context
configure>service>ies>interface>ipv6>dhcp6-relay
Description
This command specifies a list of servers where requests will be forwarded. The list of servers
can be entered as IP addresses. There must be at least one server specified for DHCP relay
to work. If there are multiple servers then the request is forwarded to all of the servers in the
list.
A maximum of 8 DHCP servers can be configured.
Default
No server
Parameters
ipv6-address — Specify the DHCP server IPv6 address.
source-address
source-address command
Item
Description
Syntax
source-address ipv6-address
no source-address
Context
configure>service>ies>interface>ipv6>dhcp6-relay
Description
This command specifies a source IPv6 address which will be used as the source IPv6 address
in all the relayed DHCPv6 messages. By default all DHCPv6 relay messages will use the
outgoing interface IPv6 address as source address.
Default
no source-address
Parameters
ipv6-address — Specify the source IPv6 address.
icmp6
icmp6 command
Item
Description
Syntax
icmp6
Context
configure>service>ies>interface>ipv6
Description
This command configures ICMPv6 for the interface.
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13