Time For Sw Update; External Number For Updating The Software; Sw Update Schedule - Siemens HiPath 1100 Programming Manual

General Programming
Step by Step
0 1
106

Time for SW Update

This setting specifies the time of day for starting the
data transfer on the specified day.
The default setting specifies the time for the update
process at 00:00 hours.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 8
: Enter the hour (00 to 23) and the minutes (00 to 59) for
h h m m
starting the update.
Initial state for Programming Mode.

External Number for Updating the Software

This setting specifies a number to be used by the sys-
tem to update the software.
The default configuration does not specify any number.
Required: Programming Mode must be active (*95
31994).
0 5 6 Enter the code for programming.
Enter the external numbers (up to 20 digits).
Press this key to finalize the entry.
#
Initial state for Programming Mode.

SW Update Schedule

This setting specifies regular intervals for transferring
data, in months. During a transfer the telephone oper-
ates as usual.
The default setting specifies updates to be done in a
monthly basis.
Required: Programming Mode must be active (*95
31994).
0 5 7 Enter the code for programming.
...
Enter a timeout for the update (01 to 12) where 01 = up-
1 2
date every month (default) 12 = update every 12
months at a specified date.
Initial state for Programming Mode.