Huawei USG6000 Series Hardware Manual page 271

HUAWEI USG6000 Series
Hardware Guide
l SIM cards are not hot swappable. Therefore, do not install the SIM card when the USG is
l Make sure that you have worn an ESD wrist strap and the strap is well grounded before
Procedure
Step 1 Determine the slot (the slot with a
Step 2 Install the SIM card and anti-theft board.
1.
2.
3.
Issue 08 (2017-06-30)
NOTE
l The USG6310S-WL-OVS/6510-WL supports standard SIM cards. If the SIM card type is Micro or
Nano, you need to purchase a SIM card tray. Because the SIM card tray and SIM card are bound
through tapes, the surface might not be smooth. Exercise caution when you remove and insert the
SIM card.
l The USG6310S-WL-OVS supports 4G LTE, 3G UMTS, and 2G GSM SIM cards. You need to
purchase the corresponding SIM card.
l The USG6510-WL supports 4G FDD LTE/TDD LTE, 3G TD-SCDMA/WCDMA, and 2G GSM
SIM cards. You need to purchase the corresponding SIM card.
NOTICE
powered on. Otherwise, the SIM card may be damaged or the function may become
invalid.
you hold the SIM card. Otherwise, the SIM card may be damaged.
NOTE
l Keep the notch on the SIM card in the same direction as the notch marked on the left of the SIM
card slot.
l Do not use too much force; otherwise the SIM card or SIM card slot might be damaged.
l The anti-theft board is delivered with the device and can be used to protect both the micro SD card
and SIM card. If both the micro SD card and SIM card need to be installed, you are advised to install
both the cards before installing the anti-theft board.
Insert the SIM card along the guide rail to the SIM card slot.
When you hear a click, the SIM card is in position.
Hook the locating hook on the anti-theft board to the locating hole of the rear panel and
tighten the captive screw on the anti-theft board.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
silkscreen on the rear panel) for installing the SIM card.
3 Hardware Installation
257