Huawei USG6000 Series Hardware Manual page 384

HUAWEI USG6000 Series
Hardware Guide
Step 4 Install the new SIM card and anti-theft board.
1.
2.
3.
Figure 4-30 Installing the new SIM card and anti-theft board
LTE DIV
Step 5 Power on the USG and start the USG.
Step 6 After the USG is started, run the display cellular command in any view to check the SIM
card status. If SIM Status in the command output is OK, the SIM card is working properly
and has been identified by the USG.
----End
Issue 08 (2017-06-30)
NOTE
l Keep the notch on the SIM card in the same direction as the notch marked on the left of the SIM
card slot.
l Do not use too much force; otherwise the SIM card or SIM card slot might be damaged.
l The anti-theft board is delivered with the device and can be used to protect both the micro SD card
and SIM card. If both the micro SD card and SIM card need to be installed, you are advised to install
both the cards before installing the anti-theft board.
Insert the SIM card along the guide rail to the SIM card slot.
When you hear a click, the SIM card is in position.
Hook the locating hook on the anti-theft board to the locating hole of the rear panel and
tighten the captive screw on the anti-theft board.
Secospace USG6000
WiFi 0
micro SD
XXXXXXXXXXXXXXXXXXXXXXXXXXX
1
micro SD
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 3 5 7
WiFi 1
0 2 4 6
CONSOLE
2
micro SD
4 Maintaining the Hardware
LTE MAIN
RST
12V ; 2A
3
micro SD
370