Selecting Cooling Discharge Temperature For Only Type K2 - Panasonic U-8ME1E81 Service Manual

3. Detailed Settings Function

Selecting cooling discharge temperature for only Type K2

(Using with the timer remote controller)
In order to prevent dew condensation or dewdrops during cooling or drying operation,
the setting of the discharge temperature can be set no lower than temperature needed.
If the installation is in a fear of high humidity area (over 80% humidity),
install the indoor unit in the following procedure.
(However, as the indoor unit capacity in the same refrigerant system
may sometimes deteriorate, make settings according to necessity.)
<Procedure>
Stop the system before performing these steps.
Press and hold the
simultaneously for 4 seconds or longer.
If group control is in effect, press the
select the address (unit No.) of the indoor unit to set.
At this time, the fan at the indoor unit begins operating.
Use the temperature setting buttons to select item code
"1C."
Make a choice from 6-level of numeric display "0000" to
"0005".
The larger the numeric display, the more effectively
dew condensation or dewdrops can be prevented.
However, as the indoor unit capacity may sometimes
deteriorate, make settings according to necessity.
Press the timer time
desired setting data.
Press the button. (The display stops blinking and
remains lit, and setting is completed.)
To change the selected indoor unit, go to step 2 .
Press the button to return to normal remote controller
display.
, and buttons
button and
/ buttons to select the
2-21
2WAY SYSTEM
Remote Controller Functions
1
2
3
4
5
6
7
8