Automatic Address Setting From The Remote Controller - Panasonic U-8ME1E81 Service Manual

3. Auto Address Setting
3. Auto Address Setting
Automatic Address Setting* from the Remote Controller
* Automatic address setting in cooling mode cannot be done from the remote controller.
Selecting each refrigerant system individually for automatic address setting
---Automatic address setting for each system: Item code "A1"
<Procedure of CZ-RTC2>
1. Press the remote controller timer time
same time. (Press and hold for 4 seconds or longer.)
2. Next, press either the temperature setting
(Check that the item code is "A1.")
3. Use either the or
automatic address setting.
4. Then press the button.
(Automatic address setting for one refrigerant system begins.)
(When automatic address setting for one system is completed, the
system returns to normal stopped status.) <Approximately 4 – 5 minutes
is required.> (During automatic address setting, "
the remote controller. This message disappears when automatic address
setting is completed.)
5. Repeat the same steps to perform automatic address setting for each
successive system.
<Procedure of CZ-RTC3>
1. Keep pressing the
for 4 or more seconds.
The "Maintenance func" screen appears on the LCD display.
2. Press the or
If you wish to see the next screen instantly, press the
button.
Select "9. Auto address" on the LCD display and press the
Maintenance func
9. Auto address
10. Set elec. consumption
11. Set touch key
12. Check touch key
Sel. Page [
3. The "Auto address" screen appears on the LCD display.
Change the "Code no." to "A1" by pressing the
Auto address
Code no.
A1
Sel. Next
4. Select the "O/D unit no." by pressing the
Select one of the "O/D unit no." for automatic address by pressing the
Then press the button.
Approximately about 10 minutes are required.
When automatic address setting is completed, the units return to normal stopped status.
button and
or
button to set the system No. to perform
SETTING
, and buttons simultaneously
button to see each menu.
20:30 (THU)
] Confirm
20:30 (THU)
O/D unit no.
1
or
button at the
button.
" is displayed on
or
button.
or button.
button.
or
1-13
2WAY SYSTEM
2WAY SYSTEM
Address Settings
Address Settings
CZ-RTC2
20:30 (THU)
[ ]
START
CZ-RTC3
button.
1
2
3
4
5
6
7
8