6. Settings
Characters used in this manual
Number
-1
Indication
Alphabet
A
Indication
Alphabet
N
Indication
6.1 Setting procedures
(1) Setup
(2) Main setting mode : Set SV in the Main setting mode.
(3) Sub setting mode : Set PID, A1 value, etc.
(4) Auxiliary function setting mode:
Power ON
Run
6.2 Setup
Setup should occur before using this controller, to set the Input type, Alarm action, Control action, etc.
according to the users' conditions.
Default values: Input (K, -200 to 1370 ), Alarm 1 type (No alarm action), Reverse (Heating) action
If the users' specifications are the same as the default value of the KT4H/B, it is not necessary to set up the
controller.
6.3 Basic operation of settings
To proceed to each setting mode, refer to instructions of each mode's section.
To set or select each setting item, use the
0
1
2
3
4
B
C
D
E
F
O
P
Q
R
S
: Set the Input type, Alarm type, etc. in the Setup mode.
(If the users' specification is the same as the default value of the KT4H/B, it is not
necessary to set.)
(If the users' PID values are the same as the default value of the KT4H/B, it is not
necessary to set.)
Select the lock function, communication conditions (serial communication option), etc.
(If the users' specifications are the same as the default value of the KT4H/B, it is not
necessary to set.)
5
6
7
8
9
G
H
I
J
K
T
U
V
W
X
or
key, then register the value with the
11
L
M
Y
Z
key.