Fuel Tank Filler Vent Hose Replacement - Suzuki XL7 2007 Service Manual

NOTE
There are 2 fuel level sender unit and float
assemblies in the fuel tank. There is 1 located
on each fuel pump module. The fuel level
sender unit and float is NOT the same for
each of the fuel pump modules.
1. Remove the fuel pump module. Refer to "Secondary
Fuel Tank Module Replacement".
2. Disconnect the fuel level sender unit and the float
electrical connector.
3. Release the retaining tabs and remove the level
sensor by sliding up.
Installation Procedure
1. Install the fuel level sender unit and float onto the
fuel pump module. Make sure that the sender cap
snaps into place.
2. Connect the fuel level sender unit and the float
electrical connector.
3. Install the fuel pump module into the fuel tank. Refer
to "Secondary Fuel Tank Module Replacement".

Fuel Tank Filler Vent Hose Replacement

Removal Procedure
1. Remove the fuel tank. Refer to "Fuel Tank
Replacement (FWD)" "Fuel Tank Replacement
(AWD)".
2. Remove the fuel tank fill vent line from the retaining
feature built into the tank.
3. Remove the fuel tank fill vent line from the fuel tank
clips.
Installation Procedure
1. Install the fuel tank fill vent line to the fuel tank clips.
2. Install the fuel tank fill vent line to the retaining
feature built into the tank.
3. Install the fuel tank. Refer to "Fuel Tank
Replacement (FWD)" "Fuel Tank Replacement
(AWD)".
Fuel System: 1G-61