Engine Oil And Oil Filter Replacement Removal Procedure; Oil Filter Adapter Replacement Removal Procedure - Suzuki XL7 2007 Service Manual

Engine Oil and Oil Filter Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Place a drain pan under the oil pan drain plug.
3. Remove the oil pan drain plug (1). Allow the oil to
drain completely.
CAUTION
!
Refer to "Fastener Notice: ".
4. Install the oil pan drain plug (1).
Tightening torque
Tighten the drain plug to 20 N⋅m (15 lb ft).
5. Place the drain pan under the oil filter.
6. Remove the oil filter. Allow the oil to drain
completely.
Engine Lubrication System:
Installation Procedure
1. Lubricate the NEW oil filter gasket with clean engine
oil.
2. Tighten the oil filter.
Tightening torque
Tighten the filter to 30 N⋅m (22 lb ft).
3. Lower the vehicle.
4. Fill the engine with oil to the appropriate mark.
5. Start the engine and inspect for leaks.
Oil Filter Adapter Replacement
Removal Procedure
1. Remove and properly dispose of the oil filter. Refer
to "Engine Oil and Oil Filter Replacement".
2. Disconnect the oil pressure sensor electrical
connector.
3. Remove the oil filter adapter bolts from the engine
block.
1E-6