0B-7 Maintenance and Lubrication:
Camshaft Timing Belt and Tensioner
Replacement
Replace camshaft timing belt (1) and tensioner (2) with
new ones referring to "Timing Belt and Belt Tensioner
Removal and Installation: For F9Q Engine in Section
1D".
Valve Lash (Clearance) Inspection
Inspect intake and exhaust valve lash and adjust as
necessary.
Refer to "Valve Lash (Clearance) Inspection: For M16A
Engine with VVT in Section 1D" or "Valve Lash
(Clearance) Inspection: For J20 Engine in Section 1D"
for valve lash inspection and adjustment procedure.
1. Camshaft
S6JB0A0206042
I5JB0B020002-01
S6JB0A0206003
I2RH0B020003-02
2. Thickness gauge
Engine Oil and Filter Change (Petrol Engine
Model)
WARNING
!
• New and used engine oil can be
hazardous.
Be sure to read "General Precautions in
Section 00" and observe what in written
there.
• Steps 1) – 7) must be performed with
ENGINE NOT RUNNING. For Step 8), be
sure to have adequate ventilation while
engine is running.
Before draining engine oil, check engine for oil leakage.
If any evidence of leakage is found, make sure to correct
defective part before proceeding to the following work.
1) Drain engine oil by removing drain plug.
2) After draining oil, wipe drain plug clean. Reinstall
drain plug.
Tightening torque
Engine oil drain plug (a): 35 N·m (3.5 kgf-m, 25.5
lb-ft)
(a)
3) Loosen oil filter by using oil filter wrench (special
tool).
Special tool
(A): 09915–40611
(A)
S6JB0A0206004
I5JB0A020003-01
I5JB0A020020-01