Fig. 10-15: Config Dialog Sinumerik* / Ftp Tab Page - Siemens Sinumerik 840D sl Function Manual

DNC Plant/DNC Cell (FBDN1)
10 Configuration
FTP tab page (SINUMERIK* machine configuration) [FTP]
The FTP tab page is the [FTP] section of the machine configuration file for
SINUMERIK* machine connections. The settings for data transmission via FTP are
made here.
Note
The FTP checkbox must be activated on the General tab page too.

Fig. 10-15: Config dialog SINUMERIK* / FTP tab page

FTP

Data transmission takes place via FTP if the FTP checkbox is activated
(UseFTP=1). The appropriate settings must also be made on the FTP tab
page.
Extract from the machine configuration file:
UseFTP = 1
Host IP address

This input field contains the IP address or the name of the DNC computer.
(The computer must be configured as the FTP server here.)
Extract from the machine configuration file:
HostIpAddress=127.0.0.0
FBDN1/10-200
© Siemens AG 2010 All Rights Reserved
Motion Control Information System DNC (FBDN) - 04/10 Edition
05.07