HP 16533A Programmer's Manual page 14

Programming the
HP 16533/34A Oscilloscope Module
Mainframe Commands
MENU
The MENU command selects the menu to be displayed on the screen. The
first parameter specifies the desired module. The optional second parameter
specifies the desired menu in the module (defaults to 0 if not specified).
For the HP 16533/34A Oscilloscope:
•
X,0 - Channel Menu
•
X,1 - Trigger Menu
•
X,2 - Display Menu
•
X,3 - Auto-Measure Menu
•
X,4 - Marker Menu
•
X,5 - Calibration Menu
X = slot number that contains the oscilloscope card
MENU?
The MENU query returns the currently selected (and displayed) menu.
SELect
The SELect command selects which module or intermodule will have parser
control. SELect 0 selects system/intermodule, and assuming the HP 16501B
extender is being used, SELect 1 through 10 selects modules A through J
respectively. Parameters -1 and -2 select software options 1 and 2.
SELect ?
The SELect query returns the currently selected module.
STARt
The STARt command starts the selected module or intermodule. If the
selected module is configured for intermodule, STARt will start all modules
configured for intermodule.
STOP
1–6