Figure 35 - Configuration STARTER PG / PC interface
At this point, you can connect the PC to the inverter to perform the following configuration tasks and the
development of the elevator.
8.4
CONNECTION PC-INVERTER
8.4.1
Connecting ONLINE
If the PC and the inverter has already been linked above, you can simply connect to target devices using the
yellow button to switch ONLINE (the inverter must be powered on).
If you are the first connection, follow these steps:
1. Connect to the target devices using the yellow button to switch ONLINE and press YES to search for
accessible nodes.
Figure 36 - STARTER connection ONLINE
2. Add the addresses corresponding to the configuration of the inverter (or to the original SIEMENS) to
enable dialogue with the PC by pressing YES, if a dedicated screen like that shown in the next
image, appears.
Siemens S120_EN_rev06-08062017.docx
8-6