Figure 37 - STARTER Adding IP addresses
3. Then select the drive and press Accept at the bottom left to turn on the inverter on the project and
then Close the same screen:
Figure 38 - Nodes STARTER / partners within
4. Press the yellow button again to connect ONLINE.
You may see a screen like shown in Figure 39, which highlights the inconsistencies between the
configuration software on the PC and the inverter.
To resolve these inconsistencies press the "Upload to PG →" and confirm subsequent screens, so that
the configuration on the PC is conformed to what is available on the machine.
Siemens S120_EN_rev06-08062017.docx
8-7