Initialize The Eeprom Parameters (Maintenance Mode 01); Restore The Head Calibration Data (Maintenance Mode 68); Set The Serial Number (Maintenance Mode 80) - Brother MFC-J3520 Service Manual

1.4

Initialize the EEPROM parameters (Maintenance mode 01)

Initialize the EEPROM parameters, referring to
Parameter Initialization."
1.5

Restore the head calibration data (Maintenance mode 68)

Restore head calibration data that has been backed up in an external memory,
referring to Chapter 5, Section 1.3.25 "Updating of Head Property Data and Backup/
Restoration of Head Calibration Data."
If the restoration is successfully completed, the procedure given in
head calibration data"
1.6

Set the serial number (Maintenance mode 80)

Set the serial number, referring to
Equipment's Log."
The serial number can also be set with the service setting tool (BrUsbSn.exe) that
enables the head property data to be updated
data") at the same time.
The serial number setting procedure is given below.
(1) Turn the machine ON and switch it to the maintenance mode.
(2) Connect the machine to your PC using a USB cable.
(3) On the PC, run the service setting tool (BrUsbSn.exe) to display the following
window.
(4) In Product Category, select 1 Ink-Model.
(5) Select 2013 Model_2.
is not required.
Chapter 5, Section 1.3.32 "Display of the
4-5
Chapter 5, Section 1.3.1 "EEPROM
(Section 1.7 "Update the head property
Section 1.15 "Write
Confidential