Siemens SIMATIC IFP Basic Series Operating Instructions Manual page 27

Requirement
● All packaging components and protective films should be removed from the device.
● To install the panel, you need the mounting clips from the accessories kit.
Procedure
Result
The device is mounted and the relevant degree of protection is ensured at the front.
IFP Basic
Operating Instructions, 03/2019, A5E46178354 - AB
Installing and connecting the device
3.2 Installing the IFP Basic
Insert the panel device into the
mounting cutout from the front.
Insert a mounting clip into the
cutout provided on the device.
Tighten the threaded pin to secure
the mounting clip. The threaded
pins have a maximum tightening
torque of 0.5 Nm.
Repeat steps 2 and 3 for all
mounting clips.
Check the fit of the mounting seal.
27