Philips ReCare 7.0 T User Manual page 26

Decline
Allows operation of the rear deck motor for decline function. This key
only operates in quick start or manual modes. When the function is
active the grade window will show a minus (-) sign indicating the
grade is set for decline.
Zero Percent
Returns the deck to zero percent when pressed.
Deck-lift program
This program allows you to raise the entire deck parallel to the oor.
In this mode the deck, rear step and hand rails can be used for
step-up, step-down, stretching and PNF/PTA exercises.
Lifting the deck while a patient walks allows the therapist to assist
the patient by moving their legs without having to bend over too far.
The deck-lift program is also used with the basic un-weighting
system. Raise the deck and connect the patient's un-weighting
harness to the un-weighting system. The up and down keys can be
used to raise or lower the deck for un-weighing the patient.
• Instructions for raising and lowering the deck
Press the deck-lift key to activate the program.
Up
1
• The grade window will display 01 which indicates the rst level. The
starting height from the step to the deck at level 1 is 5.25 inches
(13.34cm). The height will be displayed in the message window. The
height from the oor to the step is 4 inches (10 cm).
• Press the up and down keys to raise and lower the deck. There are
30 levels available with each level raising the deck ¼ inch (6.35mm).
At level 30 the deck height is 12.5 inches (31.75cm) from the step.
Note that the measurements are approximate.
• In the deck-lift program you can press the start key and the
treadmill will function normally as if in manual mode.
• When the stop key is pressed you will be prompted to con rm the
deck will be returned to the lowest level. This ensures that the deck
does not automatically lower itself to level one when a patient is
connected to the un-weighting system.
Deck-lift
2
26
Down
3