Maintenance; Belt Adjustments - Philips ReCare 7.0 T User Manual

Maintenance

• Belt and deck
Your treadmill uses a very high-e cient low-friction deck and belt.
Performance is maximized when the bed is kept as clean as
possible. Use a soft, damp cloth or paper towel to wipe the edge
of the belt and the area between the belt edge and frame. Also
reach as far as practical directly under the belt edge. This should
be done once a month to extend belt and deck life. Use water only
no cleaners or abrasives. A mild soap and water solution along
with a nylon scrub brush will clean the top of the textured belt.
Allow the belt to dry before using.
• General cleaning
Dirt, dust, and carpet bers can block air inlets and accumulate on
the running belt. On a monthly basis: vacuum underneath your
treadmill to prevent buildup. Once a year, you should remove the
motor hood and vacuum out dirt that may accumulate. Unplug
power cord before this task.

Belt adjustments

• Tread-belt tension adjustment
Adjustment must be made from the rear roller. The adjustment bolts
are located at the end of the step rails in the end caps, as noted in
diagram below.
Tracking /
Tension
Adjustment
Note:
Adjustment is through small hole in the end cap.
59
Tracking /
Tension
Adjustment