Entering System Data For A Channel - GE DigitalFlow GF868 Programming Manual

Chapter 1. Programming Site Data
1.6.1a Procedure Options
After completing the above steps, the meter returns to the
•
To continue programming the meter, refer to the menu maps in Appendix A and navigate to the desired menu.
Then, proceed to the appropriate section of this manual for instructions.
•
To leave the User Program and retain the previous settings, press
prompt. Any programming changes will be discarded and you will be returned to the data display.
•
To leave the User Program and return to measurement mode, press
SAVE prompt. Your programming changes will be entered into the meter's memory, and you will be returned to
the data display.
Note: See the
SAVE
submenu section on page 37 of this chapter for more information on this function.

1.6.2 Entering System Data for a Channel

Refer to Figure 11 on page 87.
Channel PROGRAM
1. To enter the
prompt.
2. To program the SYSTM submenu, press
IMPORTANT:
Do not confuse this
submenu of the
3. Enter a Channel Label of up to 9 characters. Press
4. Enter a Channel Message of up to 21 characters. Press
[F1]-[F4]
5. Use the [ and
10
[F1] or [F2]
menu, press
[F2]
at the
SYSTM
submenu, which is used to enter channel-specific information, with the
GLOBL
menu, which is used to enter information applicable to both channels.
keys to select the Volumetric Units for the data display, as shown in Table 2.
Table 2: Available Volumetric/Totalizer Units
English
ACF = Actual Cubic Feet
KACF = Thousands of ACF
MMACF = Millions of ACF
SCF = Standard Cubic Feet
KSCF = Thousands of SCF
MMSCF = Millions of SCF
Channel PROGRAM
[EXIT]
[EXIT]
(depending on the desired channel) at the
Channel PROGRAM
prompt.
[ENT]
.
[ENT]
.
Metric
Actual Units
ACM = Actual Cubic Meters
KACM = Thousands of ACM
MMACM = Millions of ACM
Standard Units
SCM = Standard Cubic Meters
KSCM = Thousands of SCM
MMSCM = Millions of SCM
DigitalFlow™ GF868 Programming Manual (2-Channel)
prompt. Continue as follows:
[F1] = NO
twice and then press
twice and then press
User PROGRAM
at the SAVE
[F2] = YES
at the
SYSTM