GE DigitalFlow GF868 Programming Manual page 40

Chapter 1. Programming Site Data
1.7.3 Setting Up Global Inputs/Outputs (cont.)
Option Card RTD Inputs
Option cards with RTD inputs have a temperature range of –100° to 350°C. Complete the following steps to set up the
two RTD inputs of an option card installed in Slot x:
[F1]
1. Press to set up RTD input A or
Note: The setup of RTD input A is used as an example. Identical procedures would be used to set up RTD input B.
2. Enter a label of up to eight characters and press
3. At the Input Measurement prompt, press
[F2] = TEMP
press to enable RTD input A.
4. Enter the Zero Value for the low end of the chosen input range and press
5. Enter the Full Scale Value for the high end of the chosen input range and press
[F1] [F2]
6. Press - to set up another input or press
For instructions on setting up additional inputs and/or outputs, proceed to the appropriate section. Otherwise, press
[EXIT]
twice to return to the
Procedure Options
After completing the above steps, the meter returns to the
•
To continue programming the meter, refer to the menu maps in Appendix A and navigate to the desired menu.
Then, proceed to the appropriate section of this manual for instructions.
•
To leave the User Program and retain the previous settings, press
prompt. Any programming changes will be discarded and you will be returned to the data display.
•
To leave the User Program and return to measurement mode, press
SAVE prompt. Your programming changes will be entered into the meter's memory, and you will be returned to
the data display.
Note: See the
SAVE
submenu section on page 37 of this chapter for more information on this function.
30
[F2]
to set up RTD input B.
[F1] = OFF
[EXIT]
Global PROGRAM
prompt.
[ENT]
.
to disable RTD input A and return to the previous prompt, or
to select another slot for set up.
Global I/O
prompt. Continue as follows:
[EXIT]
[EXIT]
DigitalFlow™ GF868 Programming Manual (2-Channel)
[ENT]
.
[ENT]
.
[F1] = NO
twice and then press
twice and then press
at the SAVE
[F2] = YES
at the