Mitsubishi Electric CR800 Series Instruction Manual page 8

*CR800 controller
Notes of the basic component are shown.
CAUTION
Note 1) If necessary, as shown in the figure, connects the noise filter between ACIN connector and primary power supply.
(Recommended noise filter: SUP-EL20-ER6 *OKAYA ELECTRIC INDUSTRIES)
Prepare the following items.
1)
Part name
Earth leakage breaker
Cable for primary power supply
Grounding cable
ACIN cable
2) Confirm that the primary power matches the specifications.
3) Confirm that the primary power is OFF and that the earth leakage breaker power switch is OFF.
4) Connect the ACIN cable to the breaker.
Connect the power terminals of the ACIN cable to the secondary side terminals of the earth leakage breaker.
Also, ground the FG terminal of the cable.
5) Connect the ACIN cable to the ACIN connector on the rear of the controller.
6) Connect one end of the grounding cable to the PE (protective earth) terminal on the controller and ground the
other end (2-point grounding) in order to comply with the requirements of EN 61800-5-1 for the touch cur-
rent of 3.5 mA AC or more.
7) Connect the primary power cable to the primary side terminal of the earth leakage breaker.
Please install the earth leakage breaker in the primary side supply power supply
of the controller of CR800 because of leakage protection.
Specifications
The following is recommended product.
Single phase: NV30FAU-2P-10A-AC100-240V-30mA
(Terminal cover: TCS-05FA2)
Three phase: NV30FAU-3P-10A-AC100-240V-30mA
(Terminal cover: TCS-05FA3)
2
AWG14 (2mm ) or above
2
AWG14 (2mm ) or above
Terminal: M5, cable length: 3m
Remarks
Prepared by customer.
Prepared by customer.
Tightening torque for terminal
fixing screw is 2 ～ 3Nm.
Prepared by customer.
Tightening torque for terminal
fixing screw is 2 ～ 3Nm.
Supplied with the product.