System Set-Up; Realignment - Kenwood NXR-700 Service Manual

Merchandise received
Choose the type of transceiver
Repeater programming & setup
OCXO?
NO
External speaker?
NO
Delivery
1. Modes
User mode
PC mode PC programming mode
PC test mode
Firmware programming mode
Mode
User mode Use this mode for normal operation.
Use this mode to make various settings by
PC mode means of the FPU through the RS-232C
port.
PC programming Use to read and write frequency data and
mode other features to and from the repeater.
Use to check the repeater using the PC.
PC test mode
This feature is included in the FPU.
Firmware program- Use when changing the fi rmware program
ming mode of the fl ash memory.

SYSTEM SET-UP

Frequency range
TX/RX 136~154MHz
See page 3.
A personal computer, programming interface (RS-232C Cross-wired cable),
and programming software (KPG-109D) are required for programming.
See page 90.
The RX RF BPF (TC1~TC8 on RX unit) must be aligned to obtain the
maximum sensitivity at a programmed frequency.
YES
KXK-3 (M2) installation
YES
KES-5 installation

REALIGNMENT

PC tuning mode
Function
RF power Type
25W E2
See page 6.
When using the Very Narrow Mode of the
NXR-700 repeater, install the KXK-3 (M2) (OCXO).
(Option)
See page 6.
(Option)
2. How to Enter Each Mode
Mode
User mode
PC mode
Firmware programming mode
3. PC Mode
3-1. Preface
The NXR-700 repeater is programmed by using a per-
sonal computer, programming interface and programming
software (KPG-109D).
3-2. Connection Procedure
1. Connect the NXR-700 to the personal computer with the
interface cable.
2. When power is applied, the user mode is entered imme-
diately. When the PC sends a command, the repeater
enters the PC mode and displays "PC" on the 17-seg-
ment LED. When data is being transmitted to the PC
from the repeater, the TX LED fl ashes. The BUSY LED
fl ashes when data from the PC is being received by the
repeater.
Note:
• The data stored in the personal computer must match the
model type, when it is written into the fl ash memory.
• Change the NXR-700 to PC mode, then attach the RS-
232C Cross-wired cable.
NXR-700
Operation
Power ON
Received commands from PC
Received commands from PC
3