ABB ControlMaster CM10 Manual page 13

Universal process controllers, 1/8, 1/4, 1/2 din and fieldmount

Hide thumbs Also See for ControlMaster CM10:

Table of Contents

ControlMaster CM10, CM15, CM30, CM50, CMF160 and CMF310

Universal process controllers and indicator,

...Communication

Ethernet

DHCP

IP Address

Subnet Mask

Default Gateway

IM/CM/C–EN Rev. H

Set DHCP (Dynamic Host Control Protocol) enable to On if the IP address is to be allocated

dynamically by the network. Set to Off if the IP address is defined statically.

Set the IP address to be assigned to the instrument. The IP address is used by the TCP/IP

protocol to distinguish between different devices. The address is a 32-bit value expressed with 4

values (0 to 255), each separated by a period (.).

Note. Configurable only if DHCP is disabled.

The subnet mask is used to indicate which part of the IP address is used for the network ID and

which part is used for the host ID. Set each bit that is part of the network ID as '1's, for example:

255.255.255.0 indicates the first 24 bits are for the network ID.

Note. This setting is only required if a router (or switch) is used.

Sets the IP address for the Default Gateway (router or switch) used to communicate with other

networks. The default setting is '000.000.000.000'.

DIN and fieldmount

4 Communication Level

Table of Contents