Range 1 Operating - ABB AK101 User Manual

...9 OPERATION
9.2 Range 1 Operating Page
Range 1 is selected for normal operations and the
set points can be viewed but not altered. To change the alarm set points or program other parameters refer to Section 10.
%H2 IN AIR
Alarm 1 Setpoint
Alarm 2 Setpoint
9.3 Range 2 Operating Page – AK101 only
Set to Range 2 the single Alarm Set Point value may be changed, this is displayed in the
%H2 IN *
9.4 Range 3 Operating Page – AK101 only
Set to Range 3 the single Alarm Set Point value may be changed, this is displayed in the
AIR IN *
30
Operating Page
Hydrogen Purity
Shows the percentage of hydrogen in air.
0 0 0 0 0
SECURITY CODE
Press to advance
SECURITY CODE
to next page
or
These two keys are used to advance to all subsequent parameters and pages.
Press to advance
to next parameter
Alarm 1 Set Point
The set point value is programmmable – see Section 10.3,
Alarm 2 Set Point
The set point value is programmmable – see Section 10.3,
Advance to
SECURITY CODE
xxx.x
SPT.2 H2 IN *
xxx.x
SPT.2 H2 IN *
indicates the purity of the hydrogen used as a coolant. The alarm
Access to Secure Parameters
*Note. Purge gas options include:
CO (Carbon dioxide)
2
N (Nitrogen)
2
Ar (Argon)
Set Up Outputs Page
Set Up Outputs Page
on page 28.
.
Operating Page
.
Operating Page
.
.