Charging - Silvercrest SRR 3.7 B1 Operating Instructions Manual

Rotary shaver
Hide thumbs Also See for SRR 3.7 B1:
Table of Contents

Advertisement

Available languages

Available languages

5. Charging

NOTES:
Before the device is used for the first time, and during the fol-
lowing three charging procedures, the device should be
charged for 90 minutes in each case.
The capacity/charging state of the battery 10 is displayed
in percent (00, 05, 10, ... ,100% in increments of 5%).
When the batteries are almost empty, the plug symbol 11
flashes in red. The device can then only be used for a short
time without being connected to the electricity supply.
It takes about 5 minutes to charge the device sufficiently for
one shave.
• When the battery is fully charged, the device can be used
for approximately 60 minutes without being connected to the
power supply.
1. Switch off the device with the on/off switch 9 if necessary.
2. Connect the power unit 19 to the connection 14 at the de-
vice.
3. Insert the power unit 19 into a readily accessible wall sock-
et whose voltage matches the voltage stated on the rating
plate.
4. The plug symbol 11 is lit red and the battery is charged.
When the battery is fully charged, 100% is displayed.
When the battery is fully charged, the device can be used
for approximately 60 minutes without being connected to
the power supply.
91
GB

Advertisement

Table of Contents
loading

Table of Contents