Table of Contents
Advertisement
6
SW mode & Address setting
Alert Annunciation Unit 1736 can run in SW mode 1736 - 1587 only. It shall
also have a unique address on the RS485 line connected to the 1587 board
in the FT512 C.I.E.
The SW mode 1736 – 1587 shall be used in system FT128. An optional
RS485 transceiver component 4552 is required on the main board in the
FT128 C.I.E. It shall also have a unique address on the RS485 line connected
to the main board connector "J1" or pin 15 & 16 on the FT128 termination
board. See FT128 Technical Manual.
The SW mode 1736 – 1587 shall be used in system FT1020G3. It shall also
have a unique address on the RS485 line connected to the main board
connector "J4". See FT1020G3 Technical Manual.
6.1
SW mode setting
A brand new AA unit has no SW mode. It is factory set to "Not selected" (and
is hereby not addressed). When a new AA unit is powered it will automatically
be ready for the "SW mode setting".
As an alternative, an AA unit in operation
setting" via the jumper "J4" in the unit. See the following chapter.
When the AA unit is ready for the "SW mode setting" this is indicated by the
LED "L2" (Alarms queued). The back-light is turned on and the following
information is shown in the display:
MODE SETTING!
Type: xxxxxxxxxxxx
XXXXXXXXXXXX
- 1735 – 1587 (1735 Swedish only)
-
1736 - 1587
- 1826 – 1587 2
- 1826 – 1582 2
- 1826/28 - 1587
- 1826/28 - 1582
-
1728 - 1587
- 1728 - 1582
- Not selected
Scroll to the required SW mode using push button "P1" (black). Store the
selected SW mode with the push button "P2" (yellow) and the unit will
automatically be ready for the "Address setting ", see below.
8
Or when a unit, not in operation but with the mode and address set before, is
powered.
can be changed to one of the following:
nd
Cab
nd
Cab
13
Technical Description
AAU 1736 – Rev 1
8
can be ready for the "SW mode
Change = Black
Store = Yellow
Advertisement
Table of Contents
