Activate Address Setting Mode For Du (H5/A7) - Panasonic EBL128 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01623
28.7
Action
"Access"
Scroll to menu H5.
"A"
Scroll to menu A7
"A"
E.g. "9"
"A"
E.g. "9"
"A"
"Return"
"Return"
Rev: -
Activate address setting mode for DU
(H5/A7)
This function can be used by commissioning / service engineer to
activate the address setting mode in the following Display Units
connected to the RS485 interface in EBL128:
 Ext. Presentation unit (EPU) 1728
 Alert Annunciation unit (AAU) 1735 / 1736
 Ext. Fire Brigade Panel (FBP) 1826 / 1828
A specific unit or all units can be activated for address setting.
NOTE! The units have to be in operation and in quiescent condition,
i.e. the units have to have an address set already.
Text in display
Service
Calibration of supervised outputs
Activate address setting mode for DU
Activate address setting mode for DU 0
(9 = All)
Operation failed!
All DU set in address setting mode
Activate address setting mode for DU
Service
EBL128 Operating Instructions V2.0.x
ACCEPT? H5
ACCEPT? A1
ACCEPT? A7
ACCEPT?
ACCEPT? A7
ACCEPT? H5
120
Comments
According to chapter
"Access", see page 81.
Write the unit's address (0-
7). 9 = All units.
Press "A" to accept.
If the address setting mode
was not activated.
The address has now to be
set / changed in the DU
respectively.
Scroll or press "Return" to
H5.
Scroll or press "Return".