Panasonic EBL128 Operating Instructions Manual page 6

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: -
25.3 Disable output (H2/B3) _____________________________ 88
25.4 Disable all control, ventilation, exting or interlocking outputs
(H2/B4) _______________________________________________ 90
25.5 Re-enable zone (H2/B5) ____________________________ 91
25.6 Re-enable zone / address (H2/B6) _____________________ 92
25.7 Re-enable output (H2/B7) ___________________________ 93
25.8 Re-enable all control, ventil, exting or interlocking outputs
(H2/B8) _______________________________________________ 95
25.9 Disable / re-enable alarm devices (H2/B9) ______________ 96
25.10 Disable / re-enable outputs for routing equipment (H2/B10)97
25.11 Disable / re-enable alert annunciation function (H2/B11) 98
26 Set calendar and clock (H3) __________________ 99
26.1 Daylight saving time ______________________________ 100
27 Present system status (H4) __________________ 101
27.1 Disablement (H4/U1) _____________________________ 101
27.2 Disablement by time channel (H4/U2) ________________ 102
27.3 Sensor values (H4/U3) ____________________________ 103
27.3.1 Reset of a week average sensor value _____________ 106
27.4 Sensors activating SERVICE signal (H4/U4) ___________ 107
27.5 Technical warning (H4/U5) ________________________ 108
27.6 Event log (H4/U6) ________________________________ 109
27.7 Version and alarm counter (H4/U7) __________________ 110
28 Service (H5) ______________________________ 111
28.1 Calibration of supervised outputs (H5/A1) _____________ 112
28.2 Sensitive fault detection mode (H5/A2) _______________ 114
28.3 Service mode for COM-loop (H5/A3) ________________ 115
28.4 Display current consumption in unit (H5/A4) ___________ 117
28.5 Display current consumption on COM-loop (H5/A5) ____ 118
28.6 Display statistics for COM loop (H5/A6) ______________ 119
28.7 Activate address setting mode for DU (H5/A7) _________ 120
28.8 Show information about Site Specific Data (H5/A8) _____ 121
29 FAULT Acknowledge (H6) _________________ 123
30 Perform ZONE TEST (test mode) (H7) _______ 124
31 Maintenance (H8) _________________________ 126
31.1 Disconnect / Re-connect COM loop (H8/S1) ___________ 126
31.2 Disconnect / Re-connect zone line input (H5/A2) _______ 127
31.3 Disconnect / Re-connect addressable zone interface input
(H5/S3) ______________________________________________ 128
31.4 Acknowledge SERVICE signal (H8/S4) _______________ 129
31.5 Restore weekly average to default (H8/S5) _____________ 130
31.6 Test of alarm devices (H8/S6) _______________________ 131
31.7 Safe shut down of control unit (H8/S7) _______________ 132
31.8 Activate zone-address in alarm mode (H8/S8) __________ 133
31.9 Activate output (H8/S9) ___________________________ 135
4
EBL128 Operating Instructions V2.0.x