Sw Mode Setting Via Jumper "J4; Address Setting; Address Setting Mode Via The C.i.e - Panasonic Alert annunciation unit 1736 Technical Description

6.1.1

SW mode setting via jumper "J4"

An AA unit in operation
jumper "J4" in the unit. Shunt jumper link "J4" momentarily.
When the AA unit is ready for the "SW mode setting" this is indicated by LED
"L2" (Alarms queued). The back-light is turned on and the following
information is shown in the display:
MODE SETTING!
Type: xxxxxxxxxxxx
Continue in accordance with chapter "SW mode setting", page 13.
6.2

Address setting

Following the SW mode setting, the AA unit will be ready for the "address
setting".
As an alternative, an AA unit in operation
setting" directly via the C.I.E. menu. See the following chapter.
When the AA unit is ready for the "address setting" this is indicated by the
LED "L2" (Alarms queued). The back-light is turned on and the following
information is shown in the display:
ADDRESS SETTING
Address: XX
XX can be changed to the following:
For an AA unit, the address can be set to 00-15.
Scroll to the required address with the push button "P1" (black). Store the
selected address with the push button "P2" (yellow) and the unit will
automatically restart and enter its normal operation mode.
6.2.1

Address setting mode via the C.I.E.

A specific AA unit or all the AA units connected to the same line (RS485) can,
in normal operation, from the C.I.E. receive a command and get ready for the
"Address setting" directly. This is done via menu H5/A9 (A7 in system
FT1020G3), see Operation Manual for the system respectively.
9
If "J4" is not removed, the AA unit will not enter its normal operation mode after the
restart but start from the beginning again, ready for the SW mode setting.
10
Or all the AA units connected to the same External FBP / DU interface board 1587.
11
This is the max. no. of addresses. The max. no. of units connected to a board is
dependent on type of units and if external power supply is used.
12
If the unit has no SW mode, i.e. "Not selected", it will not enter its normal operation
mode after the restart but start from the beginning again, ready for the SW mode
setting.
8
will be ready for the "SW mode setting" via the
Change = Black
Store = Yellow
10
can be ready for the "address
Change = Black
Store = Yellow
11
14
Technical Description
AAU 1736 – Rev 1
9
(Default is "00".)
12