Silvercrest SEM 0090 A1 Operating Instructions Manual page 17

 Select the desired preparation option by pressing the
(17). Once pressed, the corresponding button lights up green.
The ice-cream maker will not work if the lid is not properly attached. The
buttons on the appliance remain lit, but the motor locks so the stirrer will not
turn.
The ice-cream maker will now start to prepare the ice cream.
To add additional ingredients, such as nuts, open the lid by turning it anti-clockwise and
remove it. The appliance keeps cooling the ice cream, but the stirrer stops turning.
 Once the ingredients have been added and the lid closed, the stirrer will start to turn
again and ice cream preparation will resume.
Once the appliance has been switched on, it will cool down the temperature
in the aluminium container automatically. The preparation time will depend on
the recipe and which option has been selected:
(17). If the ice cream mixture has reached the desired consistency, you can
interrupt the process early and remove the ice cream.
 Stop the ice-cream maker before the allotted time has elapsed by pressing the
button (18). The preparation time will start again from the beginning the next time the
button is pressed.
If the ice cream becomes too thick and the motor locks so the stirrer will no
longer turn, a signal will sound 15 times and the corresponding button will
flash yellow. The ice cream will still be cooled down to the desired
consistency. The maximum operating time when preparing ice cream depends
on the recipe. A softer consistency is selected using the
the maximum operating time is approximately 90 minutes. A firmer
consistency is selected using the
time is approximately 120 minutes.
 When the time has elapsed or the appliance is switched off manually, disconnect the
plug from the mains socket.
 Remove the lid (14) with the motor block (15) and stirrer (13).
 Press the release button (1) to remove the stirrer.
 Tilt the housing to an angle of 45° (Fig. F) and use the silicone spatula supplied to
remove the ice cream from the aluminium container.
 Wait until the ice-cream maker has reached room temperature before using it again.
 Allow the aluminium container to reach room temperature again after it has been used
to prepare ice cream. Carefully clean the appliance parts (aluminium container, lid
with splash guard and stirrer) as described on Page 39.
button (16) or the
button (16) or
button (16) and the maximum operating
button
button
button (17) and
English – 37