Profile States Page - ABB COMMANDER 1911 Operating Manual

5.6 Profile States Page

PrOFLE
StAtES
OFF
ON
ProGrM
1
rS–OFF
or
rS–run
or
rS–Hld
or
rS–End
rESEt
YES
YES
ProFLE
StAtES
NO (if program running)
NO (if
program not
running)
SEG xx
SKIP–F SKIP–F
SKIP–N
SKIP–b
SKIP–b
SKIP–F
SKIP–N
Page Header – Profile States
The
,
Page ADVANCED CONFIGURATION LEVEL
reverts automatically to the first frame of the
page.
Program Select
Select the program to be run (1 to 10).
10
1
Profile Status (Ramp Soak)
rS–OFF
rUN
rS–rUN
HOLd
rS–Hld
rUN
rS–HLd
Note. If a digital input is assigned to the run/hold function, the user is
prevented from overriding the digital signal
Profile Reset
YES
If the profile is running and
NO
of the program and continues to run.
Note. To end a program, select
above) and then select
value of the first level of the selected program.
Skip Segment
The segment number (or
SKIP–F
SKIP–N
SKIP–b
For multiple skip operations, the last selection (
seconds before reverting to
switch can be programmed to jump to this frame (
/ – (Ramp Soak Run/Off) select
ON
program.
Press the
/ – (Ramp Soak Run/Hold) select
HOLd
program at current level.
Press the
– (Ramp Soak Hold) program is in the hold state, either as
a result of an operator hold, the controller is in manual or
the holdback facility (guaranteed ramp/soak). Select run
to continue running the profile if operator has stopped
program. Press the
/ – (Run/Hold End) the profile is completed, and the digital
ENd
input assigned to the profile function is still in the 'Run'
state. This frame is only displayed if a digital input is used
to run and hold the profile.
is selected, the profile returns to the beginning
YES
at this frame. The local set point value takes the
YES
) is shown in the upper display.
End
(skip forward) – abandon current segment and start next segment.
(do not skip) – maintain control using current segment.
(skip back) – return to beginning of current segment.
SKIP–N
5 CONTROL OPERATION...
Set Up Function Keys
). If the switch is used, the display
when leaving this
Operating Page
rUN to start selected
switch to activate.
to stop selected
HOLd
switch to activate.
switch to activate.
at the Profile Status frame (see
HOLd
or ) is displayed for 3
F b
.
.
19