Dispensing Hot Water; Replacing An Empty Bottle - Sharp SWD-77EH-BK Quick Start Manual

1. Position the bottle, glass, pitcher, or cooking pot securely below the cold water tap.
• The right triangle below the cold water control indicates the location of the cold water
tap(See Parts & Features NO. 5).
• The circular shapes in the drip plate help align the flow of water. This unit dispenses
water at a fast rate. To avoid splashes, hold the cup as close to the tap as possible.
2. Press the right control downward to start dispensing water.
3. Release the control once desired the fill level is achieved.

Dispensing Hot Water

Note: After setup, hot water will be available in 15-20 minutes.
1. Position the bottle, glass, pitcher or cooking pot securely below the hot water tap.
• The left triangle below the hot water control indicates the location of the hot water
tap(See Parts & Features NO. 4).
• The circular shapes in the drip plate help align the flow of water. To avoid splashes,
hold the cup as close to the tap as possible.
2. Push the hot water release button (red) inward and press the control downward to start
dispensing water.
3. Release the control once desired the fill level is achieved.

Replacing an Empty Bottle

Note: When your bottle is empty, the dispenser will beep intermittently and the LED night lights
will blink until a fresh bottle is connected.
You may also hear a sucking sound when the bottle empties. This is normal and is another
way to be alerted that your bottle is empty.
Replace the bottle as soon as you notice that it is empty. If unavailable,
LEAVE THE DOOR AJAR OR UNPLUG THE COOLER TO STOP THE BEEPING NOISE
AND FLASHING LIGHTS.
There may be a small amount of water left in the bottle. This is normal.
1. Open door and slide bottle out.
2. Remove the probe from the bottle:
• Pull the probe straight up until completely out of bottle.
3. Install the bottle:
• Place the fresh bottle in front of the tray.
• Clean the fresh bottle using a soft cloth and warm soapy water and then rinse.
• Remove the entire plastic cap from the top of the bottle.
• Insert the probe into bottle.
• Push the probe down until it is seated.
• Slide the bottle onto the tray and close the door completely.
WARNING
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
11