Cleaning Prior To Initial Use - Sharp SWD-77EH-BK Quick Start Manual

CLEANING PRIOR TO INITIAL USE

To remove any odors or dust that may have accumulated during shipment, you may
want to clean the dispenser prior to first use.
Time Required: 45 minutes.
Notice: Do NOT plug in power cord yet.
1. Move the dispenser away from the wall and turn it 90° in either
direction.
2. Turn the power switches to OFF.
3. Remove the water bottle and the probe from the water bottle.
4. Place a 2 gallon or larger bucket under the probe assembly.
5. Take apart the probe assembly, wash the probe parts by hand in
soapy water or in the dishwater.
6. Remove the air filter and wash it in soapy water.
7. Submerge the probe hand in the soapy water and rinse properly.
8. Reattach back all parts of the probe assembly.
9. Spray the dispensing nozzles of water faucets with chlorine
solution (1 teaspoon of unscented bleach composition
(I.E.5.25% sodium hypochlorite) in one glass of water).
10. Place a 2 gallon or larger bucket under the drain plug in the
rear of the dispenser.
11. Once the unit has been drained, replace the drain plug and
drain the cap.
12. Remove remaining water from the reservoirs by dispensing
it from the cold tap into a pitcher.
Rinsing
13. Fill bottle with 2 gallons or tap water.
14. Insert probe assembly, place bottle into water cooler and
close the door.
15. Allow cooler to be filled with water.
16. Drain water out as in steps 10, 11 and 12.
17. If chlorine taste persist, repeat rinsing procedure.
18. Complete the installation and follow the operation instructions indicated in this manual. If
your
water has an off-taste, do not return the dispenser to the store. Call 0-800-1-225588 for
assistance.
8
A
B