Sharp SWD-77EH-BK Quick Start Manual page 15

Top and bottom load water dispenser
Table of Contents

Advertisement

Step D: Rinse Reservoirs
1. Dispose of the water and bleach mixture and rinse the bottle with tap
water.
2. Fill the bottle with tap water and insert the probe into the bottle.
3. Push the probe down until it is seated.
4. Slide the bottle into the cabinet and close the door.
Excessive Weight Hazard
Use two or more people to move and install bottles.
Failure to do so can result in back or other injury.
5. Plug the power cord into a grounded wall outlet.
6. Turn the energy saving switches ON.
7. Allow the water to fill up the empty reservoirs.
8. Wait 10 minutes then turn the energy saving switches OFF and unplug the power
cord.
9. Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser.
10. Remove the drain cap and the drain plug. Cold water will immediately flow into the
bucket. After several seconds, hot water will be dispensed.
Reminder - place the drain cap and the drain plug in a safe location so that they
will not be lost.
11. Once the unit has been drained, replace the drain plug and the drain cap.
12. Remove the remaining water from the reservoir by dispensing from the cold tap
into a pitcher.
13. Return the unit to its location, install a fresh water bottle, plug the power cord back
into the grounded wall outlet and turn the energy saving switches ON.
14. The display shows the time of the day, and every 30 seconds it will flash the time
of its next self-cleaning, When self-cleaning occurs, it will flash the words: "SELF
CLEANING" Display time setting.
15. How to switch off the beeping signal: the bottle icon on the display will flash and
beep when the bottle is empty. To turn the beeper off, touch the words on the
panel marked BEEP ON/OFF for 3 seconds. The Beep ON or OFF markings are
shown here.
WARNING
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
15

Advertisement

Table of Contents
loading

Table of Contents