Toro Groundsmaster 4100 Operator's Manual page 17

To engage the parking brake, connect the pedals with
the locking latch, push down on both pedals, and pull
the parking-brake latch out. To release the parking
brake, press both pedals until the parking-brake latch
retracts.
Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
Engine-Speed Switch
The engine-speed switch
change the engine speed. Tap the switch to increase
or decrease the engine speed in 100 rpm increments.
Hold down the switch to automatically move to High
or Low idle, depending on which end of the switch
you press.
4) has 3 positions: O
.
Figure 4
5. High-Low speed control
6. Engine-speed switch
7. Light switch (optional)
(Figure 4) has 2 modes to
PTO Switch
The PTO switch has 2 positions: O
I ( ). Pull the PTO button out to engage the
N STOP
mower-deck blades. Push the button in to disengage
the mower-deck blades
High-Low Speed-Control Switch
,
FF
The High-Low speed-control switch allows the speed
range to increase for transport of the machine
4).
Mower decks do not operate in high range. To switch
between the H
disengage the PTO and the cruise control, move the
traction pedal in the N
machine move at a slow speed.
Lift Switches
The lift switches raise and lower the mower decks
(Figure 4). Press the switches forward to lower the
g028453
mower decks and rearward to raise the mower decks.
When starting the machine, with the mower decks in
the down position, press the lift switch down to allow
the mower decks to float and mow.
Note:
The decks do not lower while in the high-speed
range and they do not raise or lower if you are out of
the seat while the engine is running. Also, the decks
lower with the key in the O
the seat.
Cruise-Control Switch
The cruise-control switch locks in the pedal position
to maintain the desired ground speed
Pressing the rear of the switch turns off the cruise
control, the middle position of the switch enables the
cruise-control function, and the front of the switch sets
the desired ground speed.
Note:
Pressing either brake pedal or moving the
traction pedal into the R
also disengages the pedal position.
17
UT
(Figure 4).
and L range, raise the decks,
IGH OW
position, and have the
EUTRAL
position and you are in
N
position, for 1 second,
EVERSE
( ) and
START
(Figure
(Figure 5).