Aiming The Headlights; Adjusting The Rollover Protection System (Rops) - Toro Groundsmaster 4100 Operator's Manual

Aiming the Headlights

Optional Accessory
1. Loosen the mounting nuts and position each
headlight so that it points straight ahead.
Note:
Tighten the mounting nut just enough to
hold the headlight in position.
2. Place a flat piece of sheet metal over the face of
the headlight.
3. Mount a magnetic protractor onto the plate.
4. While holding the assembly in place, carefully tilt
the headlight downward 3°, then tighten the nut.
5. Repeat the procedure on the other headlight.
Adjusting the Rollover
Protection System (ROPS)
WARNING
To avoid injury or death from rollover: keep
the roll bar in the raised locked position and
use the seat belt.
Ensure that the seat is secured with the seat
latch.
WARNING
There is no rollover protection when the roll
bar is in the down position.
• Do not operate the machine on uneven
ground or on a hillside with the roll bar in
the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(i.e., branches, doorways, electrical wires)
before driving under any objects and do
not contact them.
Lowering the Roll Bar
Raising the Roll Bar
25
Figure 15
Figure 16
g221650
g221651