Checking The Rear-Axle Lubricant; Checking The Rear-Axle-Gearbox Lubricant - Toro Groundsmaster 4100 Operator's Manual

Figure 105
1. Drain plug
4. When all of the oil has drained from both
locations, install the plug in the brake housing.
5. Rotate the wheel until the open plug hole in the
planetary is at the 12 o'clock position.
6. Through the open hole, slowly fill the planetary
with 0.65 L (22 fl oz) of high quality SAE
85W-140 wt gear lube.
Important:
If the planetary fills before the
0.65 L (22 fl oz) of oil is added, wait 1 hour
or install the plug and move the machine
approximately 3 m (10 ft) to distribute the oil
through the brake system. Then, remove the
plug and add the remaining oil.
7. Install the plug.
8. Repeat the procedure on the opposite
planetary/brake assembly.
Checking the Rear-Axle
Lubricant
Service Interval: Every 400 hours
The rear axle is filled with SAE 85W-140 gear lube.
Check the lubricant level before you first start the
engine and as recommended. The capacity is 2.4 L
(80 fl oz). Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove a check plug from the end of the axle
and ensure that the lubricant is up to the bottom
of the hole (Figure
Note:
If the level is low, remove the fill plug and
add enough lubricant to bring the level up to the
bottom of the check-plug holes.
2. Brake housing
106).
g020680
1. Check plug
Checking the
Rear-Axle-Gearbox
Lubricant
Service Interval: Every 400 hours
The gearbox is filled with SAE 85W-140 gear lube.
The capacity is 0.5 L (16 fl oz). Visually inspect for
leaks daily.
1. Position the machine on a level surface.
2. Remove the check/fill plug from the left side of
the gearbox and ensure that lubricant is up to
the bottom of the hole
Note:
If the level is low, add enough lubricant to
bring the level up to the bottom of the hole.
1. Gearbox
71
Figure 106
2. Fill plug
(Figure 107).
Figure 107
2. Check/fill plug
g011487
g011488