Toro Groundsmaster 4100 Operator's Manual page 27

Note:
When using 25 mm (1 inch), 38 mm
(1-1/2 inch), or occasionally 51 mm (2 inch)
height-of-cut, move the skids and gage wheels
to the highest position.
Wing Mower Decks
To adjust the height of cut on the wing mower decks,
add or remove an equal number of spacers from the
caster forks, position the caster-wheel axles in the
high or low height-of-cut holes in the caster forks, and
secure the pivot arms to the selected height-of-cut
bracket holes.
1. Position the caster-wheel axles in the same
holes in all of the caster forks
Figure 23).
2. Remove the tensioning cap from the spindle
shaft and slide the spindle out of the caster arm
(Figure 21).
1. Tensioning cap
2. Spacers
3. Shims
3. Install 2 shims onto the spindle shaft as they
were originally installed.
Figure 20
(Figure 21
Figure 21
4. Top axle-mounting hole
5. Caster wheel
Note:
level across the entire width of the mower decks.
Slide the appropriate number of 13 mm (1/2
inch) spacers (refer to the chart below) onto the
spindle shaft to attain the desired height-of-cut,
then slide the washer onto the shaft.
Refer to the following chart to determine the
combinations of spacers for the setting
22).
decal106-4251nc
4. Push the caster spindle through the front caster
arm.
5. Install the shims (as they were originally
installed) and the remaining spacers onto the
spindle shaft.
and
6. Remove the hairpin cotter and clevis pins from
the caster-pivot arms
7. Rotate the tension rod to raise or lower the pivot
arm until the holes are aligned with the selected
height-of-cut bracket holes in the mower-deck
frame
g008866
1. Caster-pivot arm
2. Axle-mounting holes
27
These shims are required to achieve a
Figure 22
(Figure
(Figure 23 and Figure
Figure 23
3. Clevis pin and hairpin
cotter
4. Tension rod
(Figure
decal100-5622nc
23).
24).
g004676