Required Tools And Materials; Decommissioning And Disposal; Cabling Recommendations - Siemens RUGGEDCOM RX1400 Installation Manual

Introduction
1.3 Required Tools and Materials
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RX1400:
WLAN, LTE and/or GPS antennas
Antenna N-connect and/or SMA cables
AC/DC power cord (16 AWG)
Lightning protector
Shielded coaxial cables
SIM card(s) provided by the network carrier
Flathead screwdriver for mounting the device to a DIN rail
Phillips screwdriver for mounting the device to a rack or panel
Braided or equivalent ground wire for grounding the device
a
For more information, contact a Siemens Sales representative.
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated User Guide.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related acces-
sories, contact a facility certified to dispose of waste electrical and electronic equip-
ment. Recycling and disposal must be done in accordance with local regulations.
1.5

Cabling Recommendations

Siemens recommends using SIMATIC NET industrial Ethernet shielded cables for all
Ethernet ports.
4
Tool/Material Available For Pur-
chase From Siemens
ü
ü
û
û
û
û
û
û
û
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13
a