Configuring The Device; Installing The Sim Cards - Siemens RUGGEDCOM RX1400 Installation Manual

Device Management
3.2 Configuring the Device
For information about how to connect to the device via the serial console port, refer
to the RUGGEDCOM RX1400 CLI User Guide for the RUGGEDCOM RX1400.
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RX1400 console and Web interfaces via the device's
IP address. The factory default IP address for the RUGGEDCOM RX1400 is
192.168.0.2.
For more information about available ports, refer to
29)".
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured. All
configuration management is done via the RUGGEDCOM RX1400 interface. For more
information about configuring the device, refer to the RUGGEDCOM RX1400 User
Guide associated with the installed software release.
3.3

Installing the SIM Cards

The RUGGEDCOM RX1400 supports dual micro-SIM cards for the LTE modem to pro-
vide a fail-over mechanism should one of the SIM cards lose connectivity with the
network.
To install micro-SIM cards from a regional cellular carrier, do the following:
Static electricity hazard – risk of damage to equipment.
Take appropriate anti-static precautions before accessing the SIM cards.
26
Pin
8
9
CAUTION
Name
Reserved (Do Not Connect)
Reserved (Do Not Connect)
https://-
"Communication Ports (Page
Installation Manual, 09/2019, C79000-G8976-1103-13
RUGGEDCOM RX1400