Csa/Sira - Siemens RUGGEDCOM RX1400 Installation Manual

Certification
6.1.2 CSA/Sira
The device is marked with a CSA symbol that indicates compliance with both Canadi-
an and U.S. requirements.
C
It is specifically approved for use in hazardous locations defined as:
•
•
•
A copy of the CSA Certificate of Compliance is available via Siemens Industry Online
Support at https://support.industry.siemens.com/cs/ww/en/view/109744578.
6.1.2

CSA/Sira

This device meets the requirements of the following CSA/Sira standards and is ap-
proved for use in hazardous locations under certificates Sira 15ATEX4323X and IECEx
CSA 16.0004X:
•
•
•
The device is marked with an ATEX marking.
Note
For the maximum ambient temperature, refer to the hazardous location label affixed
to the device.
A copy of the CSA/Sira Certificate of Compliance is available via Siemens Industry On-
line Support at https://support.industry.siemens.com/cs/ca/en/view/109747427.
44
US
Class I, Division 2, Groups A, B, C, D
Ex nA nC IIC T4 Gc
Class I, Zone 2, AEx nA nC IIC T4 Gc
Directive 94/9/EC (ATEX)
ATEX – Directive of the European Parliament and the Council of 23 March 1994
on the Approximation of the Laws of the Member States Concerning Equipment
and Protective Systems Intended for Use in Potentially Explosive Atmospheres
IEC 60079-0, Edition 6.0 (2011)/EN 60079-0:2012
Explosive Atmospheres – Part 0: Equipment – General Requirements
IEC 60079-15, Edition 4.0 (2010)/EN 60079-15:2010
Explosive Atmospheres – Part 15: Equipment Protection by Type of Protection N
II 3 G Ex nA nC IIC T4 Gc
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13