Fcc - Siemens RUGGEDCOM RX1400 Installation Manual

Notices specific to the European Union:
NOTICE
For mobile and fixed operating configurations, in accordance with R&TTE Directive
1999/5/EC, the maximum antenna gain is 3 dBi for 900 MHz, 1800 MHz, 2100 MHz
and 2600 MHz.
6.1.5

FCC

This device has been tested and found to comply with the limits for a Class B digi-
tal device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the device is operated in a
commercial environment.
This device generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this device does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
•
•
•
•
Notes specific to the FCC:
NOTICE
Changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate this device.
NOTICE
This device is to be used only for mobile and fixed applications. The antenna(s) used
for this transmitter must be installed to provide a separate distance of at least 35 cm
from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter, except in accordance with FCC multi-transmitter eval-
uation procedures.
This device contains FCC ID: N7NMC7355 WWAN Cellular/PCS GSM/EDGE/CD-
MA/WCDMA/LTE Modem.
The WWAN antenna gain, including cable loss, must not exceed 3 dBi at 850 MHz, 3
dBi at 1900 MHz, 6 dBi at 700 MHz and 6 dBi at 1700 MHz.
RUGGEDCOM RX1400
Installation Manual, 09/2019, C79000-G8976-1103-13
Reorient or relocate the receiving antenna
Increase the separation between the device and receiver.
Connect the device into an outlet on a circuit different from that to which the re-
ceiver is connected
Contact Siemens Customer Support for assistance
Certification
6.1.5 FCC
47