Communication Ports - Siemens RUGGEDCOM RX1512 Installation Manual

Chapter 3
Device Management
a
The DSR, DCD and DTR pins are connected together internally.
b
The CTS and RTS pins are connected together internally.
c
RI is not connected.
For information about how to connect to the device via the serial console port, refer to the RUGGEDCOM ROX II CLI
User Guide for the RUGGEDCOM RX1512.
For information about how to connect to the device via the management port, refer to either the RUGGEDCOM
ROX II Web Interface User Guide or the RUGGEDCOM ROX II CLI User Guide for the RUGGEDCOM RX1512.
The management port is a 10/100Base-TX copper Ethernet port with an RJ-45 connector. The following is the pin-
out for the management port:
8
Figure 10: RJ-45 Management Port

Communication Ports

Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROX II console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RX1512 is https://192.168.0.2
For more information about available ports, refer to
NOTE
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
14
1
.
Chapter 4, Modules
Pin
DB9
RJ-45 Male
Female
7 8
8 7
9
Pin Name
1 RX+
2 RX-
3 TX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 TX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
.
RUGGEDCOM RX1512
Installation Guide
Name Description
b
CTS Clear to Send
b
RTS Read to Send
c
RI Ring Indicator
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
Connecting to the Device