Siemens SCALANCE W1780 Configuration Manual page 130

Configuring with Web Based Management
6.4 "Information" menu
Description
The table has the following columns:
● Port
Shows the available VAP interfaces.
● Destination Address / State
Shows which destination address is monitored and the status of the connection. You
configure the destination address in "Interfaces > WLAN > Force Roaming".
– Not configured: No destination address is configured.
– Idle: The destination address was not found.
– Up: The destination address is reachable.
– Down: The destination address is not reachable.
● IP address not reachable - Force roaming
Indicates whether roaming is currently being performed.
– Inactive: The client is not forced to perform roaming. The corresponding VAP interface
– Active: None of the destination addresses is reachable. To force the logged on clients to
130
is not deactivated.
roam, the access point has disabled the relevant VAP interface.
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03