Faults - Siemens SCALANCE W1780 Configuration Manual

Configuring with Web Based Management
6.4 "Information" menu
The table has the following columns:
● Restart
Counts the number of restarts since you last reset to factory settings and shows the device
restart after which the corresponding event occurred.
● System Up Time
Shows the time the device has been running since the last restart when the described event
occurred.
● System Time
Shows the date and time when the described event occurred.
● Severity
Shows the severity of the message.
● Log Message
Displays a brief description of the event that has occurred. You will find the list of possible
messages in Appendix D (Page 349) of the configuration manual.
If the system time is set, the time is also displayed at which the event occurred.
6.4.6

Faults

Error status
If a fault occurs, it is shown on this page. On the device, faults are indicated by the red fault LED
lighting up.
Internal faults of the device and faults that you configure on the following pages are indicated:
● "System > Events"
● "System > Fault Monitoring"
The calculation of the time of a fault always begins after the last system start. If there are no
faults present, the fault LED switches off.
98
SCALANCE W1780/W1740 according to IEEE 802.11ac Web Based Management
Configuration Manual, 11/2019, C79000-G8976-C485-03